View Single Post
Old 08-04-2009, 12:04 PM   #6
 
bobolinko's Avatar
bobolinko
Member
Full Access Member
 
Join Date: Jun 2009
Location: Hawaii - Moved to Everett WA 2012
Name: Bob
Posts: 87
Default Made um at home
No welding required.

Just bent 2 pieces of flat iron to form the mounting bracket, and drilled the holes to bolt them to the necessary points. 2 bars, 4 holes. Not hard, just must make sure the angles are where you want them to be. I used a piece of wire hanger to make the template for the bending, which was done in an old bench vise. came out pretty good, I'd say... :>)
bobolinko is offline   Reply With Quote