Originally Posted by bobolinko
Hi Ted,
Nice job you did! I have been waiting to seee your final results, but in the meanwhile, I need some help/info if you can. I tried to install a Strupp CEL Eliminator, and it requires the dropping of the pipes to install in the O2 Sensor bung. I needed to remove the 2 bolts in the springs at the top of the cat pipe and they DON'T BUDGE !! I used an impact gun that I used to remove the Crank Pulley Bolt, and that couldn't even turn the bolts a smidgen. My bolts are not a bit rusty, and I'm sure rust is not the reason they are'nt moving. Please tell me how you take off those 2 bolts. They're really pissin me off. !!!
|
You couldnt get them off with an impact gun? I hate to ask a stupid question, and I apologize if it offends you, but are you sure you set the gun to loosen the bolts and not tighten them?