Scion XD Forum - View Single Post

THEHMONGYAJ87 · 05-26-2011, 01:51 PM

Basically you just need the stack, a coupler and a 6" inlet filter. I'm planning on using the oem Maf sensor pipe and the stock intake arm until I can find a better replacement for it. I wanted a silicone intake tube intsead of the aluminum pipe intake to reduce as much heat soak as possible. The one bought is a BPI stack with a k&n filter from this website http://www.bpinitiatives.com/?gclid=...FRs5gwodWDK0rA
kinda pricey but the r&d put into making this is worth it. The one you posted up is made by blox, a replica of the BPI stack, however they offer it in aluminum and different anodize colors.
[IMG]

[/IMG]
[IMG]

[/IMG]

---------- Post added at 11:51 AM ---------- Previous post was at 11:48 AM ----------

I haven't found a picture of a xD with one yet so I'll post one up of after installation with and without filter.

05-26-2011, 01:51 PM	#15
THEHMONGYAJ87 Junior Member Join Date: May 2011 Name: Enter your name or name you wish to be refered to as. Age: 37 Posts: 29	Basically you just need the stack, a coupler and a 6" inlet filter. I'm planning on using the oem Maf sensor pipe and the stock intake arm until I can find a better replacement for it. I wanted a silicone intake tube intsead of the aluminum pipe intake to reduce as much heat soak as possible. The one bought is a BPI stack with a k&n filter from this website http://www.bpinitiatives.com/?gclid=...FRs5gwodWDK0rA kinda pricey but the r&d put into making this is worth it. The one you posted up is made by blox, a replica of the BPI stack, however they offer it in aluminum and different anodize colors. [IMG][/IMG] [IMG][/IMG] ---------- Post added at 11:51 AM ---------- Previous post was at 11:48 AM ---------- I haven't found a picture of a xD with one yet so I'll post one up of after installation with and without filter.