Originally Posted by bobolinko
No welding required.
Just bent 2 pieces of flat iron to form the mounting bracket, and drilled the holes to bolt them to the necessary points. 2 bars, 4 holes. Not hard, just must make sure the angles are where you want them to be. I used a piece of wire hanger to make the template for the bending, which was done in an old bench vise. came out pretty good, I'd say... :>)
|
when reffering to the flat iron are you talkin about the mounting brackets purchased at home depot? cus im really interest in this project. and did you paint it yourself or it came like that.