Originally Posted by SciFion
It came with instructions, and it has a small round switch button like a rocker switch with a little picture of a seat on it. I was thinking of drilling a hole into one of the blanks and putting in the round switch, but remembered that Scion factory type rocker switches are available from Oznium I believe. And those blanks are set up to fit those perfectly it looks like.
Was just thinking it would look better with those switches that were designed to go in the blanks.
But now the question is, how to find a way past the firewall. Should I just drill a small hole, or keep searching around to find where the wiring harness goes through? Everything is so crammed in there together it's difficult to see where the wires go through.
|
I've used the panel before for my headunit dvd ebrake bypass. the panel just snaps off and same with each individual plate pops right out... i used a small round switch and simply popped one of the tabs out and used a unibit/step drill to get a nice centered hole to the right size and it popped right in, looks great.
Id recommend not using the scion factory switches, the one that i got for scion factory switch pieces was too big, and is apparently only for the tc/xb